DK EN DE

TERTEK COMBI ANTENNA FOR FLAGPOLES

Digital Combi Omnidirectional Antenna for Flagpoles

PC WORLD has tested the antenna. See the article here

Advantages of the Tertek® Combi Antenna: Optimal signal reception at a great height, especially where the signal coverage is poor. Only one antenna, TV/radio signals (DVB-T, T2, UHF, VHF, DAB, DAB+ & FM). Can be mounted everywhere where it is allowed to have a flagpole (also in areas where antennas may not be mounted). Can be mounted on existing flagpoles (fibreglass). Not visible in the environment (it is integrated in a standard flagpole knob). It is extremely wind resistant. Up to 28 db amplification. No interference from electrical installations and mobile phones in the building.

Download the mounting guidelines here

Specifications for TERTEK 4G/LTE SAFE version III

Specifications for TERTEK 4G/LTE SAFE version III

Diode colour Yellow
4G/LTE Safe Yes
TETRA Safe Yes
Colour selection Red, white and yellow
Noise count <3,0 dB
Max. Output level 108/104 dBμV
Power consumption 50mA
Width 190 mm
Height 120 mm
Channel DVB-T/ T2/FM/DAB/DAB+/5-12/21-60
Elements 1+ pcs.
Impedance 75 Ohm
Power supply 12/230 volt
5 volts from the receiver Yes
Band BIV/V
Opening angle, horizontal 360 degrees
Opening angle, vertical 180 degrees
Wind load 5.5 N
Frequency range DAB 174-300Mhz
Frequency range FM 87,5-108Mhz
Connector F-connector
Frequency range VHF 174-300Mhz
Frequency range UHF 470-790Mhz

When mounting, a coax grounding cable is routed from the TERTEK antenna into the housing in the supplied amplifier/signal distributor 12 or 220 volts.

Mounting guidelines for TERTEK® Combi Antenna for Flagpoles

flagstangred

 

 

 

 

 

 

knop

 

 

 

 

 

 

201_s